HOW TO CHECK IF A KEY IS BEING HELD DOWN?

Posts

Pages: first prev 123 last
You need to end processing the Attack event and turn the "Attacking Enabled" switch off, under the branch where you press RIGHT. This is assuming you only want to attack once per roll win.

Otherwise after the 0.5 seconds of wait in that conditional branch, it'll restart again, causing the picture 8 in the release counter branch, rps_talmit01, to appear. I'm assuming that's your idle stance.

Or if you happen to be holding down RIGHT, every 0.5 seconds, it'll do the attack animation again and again, and quickly revert to idle when you let it ago.

That's my best guess. I didn't look thoroughly, though.
Where exactly should I put End Event Processing and Attacking Enabled switch off?
Under the branch Attack - 3. At the end of that section, but not inside the branch for "Time until defend = 15."

So, I'm not sure, but it looks like you need to put it right under the Variable 0010 "Enemy hurt animation counter" Set 0 near the bottom.

Make sure you turn the switch off first, then end the process, otherwise the process will run through one more time.
Pages: first prev 123 last